Eddyfi Technologies Ectane 3 - General

52
1. General
This section presents the general specifications of the Ectane 3.
System
Warm-up
a
15 minutes
Workstation link
Ethernet 1000BASE-T
Transfer rate on Ethernet
cable
1 Gbps
a
The warm-up time corresponds to the time required by the unit to reach its optimal accuracy
after it is turned on. Eddyfi recommends waiting until the end of the warm-up period before balancing
probes or performing acquisitions.
Power Requirements
Power configuration
100 W external AC/DC power
supply of 15 VDC or battery
(removable)
Voltage
100 – 240 VAC, ±10 %
Frequency
50 / 60 Hz
Maximum input current
1.5 A
Battery type
Li204SX-7800 rechargeable
Lithium- ion, DOT-compliant
Battery autonomy
a
8 hours
a
Typical (with two batteries in the instrument)