61
Calibration consists in a standard battery charge followed by a deep discharge, and a
complete charge. This procedure usually takes between 10 and 13 hours, whereas a standard
charge only takes about 3.5 hours.
Calibrate batteries by placing them in the optional, external charger and then pressing the
recalibrate button. (See Charging the Batteries on page 35)
Eddyfi recommends calibrating your batteries at least once every six months.
During calibration, the charger may become warm.
3. Troubleshooting
To troubleshoot the Ectane 3, you must first connect it to a workstation running Magnifi®.
Troubleshooting information is found in the Magnifi documentation.
4. Firmware Corruption
If the Ectane 3 firmware becomes corrupted, you must start the instrument from a backup
firmware. This procedure is explained in the Magnifi documentation.
To locate the backup firmware button, see Battery Compartment on page 23.
To Next Page
Loading...