Eddyfi Technologies Ectane 3 - Page 56

56
Connector type
a
Single or double, 160-pin
connector
•
The Ectane 3 uses an ID device found in Eddyfi probes. This ID device contains information that helps set up acquisitions and confirm
compatibility between setup and probe.
Remote/Near-Field Testing (RFT/ NFT)
Probe inputs
4 on 19-pin RFT/NFT/MFL
connector
8 on 41-pin EXTENDED ET
connector
Number of frequencies
5
Frequency range
5 Hz – 250 MHz
Generators/Coil drivers
2
Generator output/Coil drive
20 V, peak-to-peak
Receiver gain
50 dB range, 36 – 86 dB
Acquisition/Sampling rate
Up to 20 000 per second
Connector type
19-pin RFT/NFT/MFL connector
41-pin EXTENDED ET connector
Remote Field Array (RFA)
Probe inputs
Up to 32
Number of frequencies
2
Frequency range
5 Hz – 2 kHz