Chapter 2
| Installation Overview
AP Installation Tasks
– 17 –
Figure 7: System LEDs
Make Initial Configuration Changes
The AP is designed to be managed from a wireless access controller (EWS4502 or
WAC4502) through the Control and Provisioning of Wireless Access Points
(CAPWAP) protocol. However, you can also make manual configuration changes to
the AP so that it is compatible with your network.
To make manual configuration changes to the AP, such as set an IP address, it is
suggested to connect to the AP console port.
For more information, go to “How to Connect to the Console Port”
System Status LEDs.
To Next Page
Loading...
Need help?
General
