Edge-Core ES3510MA User Manual (English)

Other manuals for Edge-Core ES3510MA

Questions and Answers:

S
Shawn HowardAug 2, 2025
What to do if there is a system fault on Edge-Core ES3510MA?
- O
  ortegamatthewAug 2, 2025
  If you encounter a system fault with your Edge-Core Switch, start by consulting the Installation Guide to confirm the switch is indeed the cause of the problem. Then, enable logging, configure error messages to include all categories, and enable SNMP and SNMP traps, designating an SNMP host to receive error messages. Finally, repeat the actions leading up to the error. Also, document the commands or circumstances causing the fault, along with any error messages displayed. If the issue persists, contact your distributor’s service engineer.
H
Holly LoweAug 9, 2025
What to do if the Link LED is off on an Edge-Core ES3510MA Switch?
- J
  joseph38Aug 10, 2025
  If the Link LED is off on your Edge-Core Switch, start by ensuring both the switch and the connected device are powered on. Confirm that the cable is securely plugged into both the switch and the corresponding device. If the switch is part of a rack installation, inspect the connections to the punch-down block and patch panel. Also, make sure you're using the correct type of cable and that its length is within the specified limits. Finally, examine the adapter on the connected device and the cable connections for any signs of damage; replace any defective components as needed.
O
ortizbryceAug 17, 2025
How to troubleshoot a Power LED that is off on an Edge-Core Switch?
- U
  uperezAug 17, 2025
  If the Power LED on your Edge-Core Switch is off, first check the connections between the switch, the power cord, and the wall outlet to ensure everything is properly connected. If the problem persists, it is recommended to contact your dealer for further assistance.
B
brendan37Aug 25, 2025
What to do if the DIAG LED is on amber on an Edge-Core ES3510MA?
- M
  matthew58Aug 25, 2025
  If the DIAG LED on your Edge-Core Switch is amber, try power cycling the switch to clear the condition. If the amber light persists after restarting, it's best to contact your dealer for further assistance.