124
The Status icon displays grey (disconnected), red (authentication
failed/incompatible NMS version), orange (upgrading firmware), yellow
(connecting), green (connected) or blue (waiting for approval) for each
individual Managed AP.
The “Action” icons enable you to allow or disallow an AP:
Select an AP or AP group using the check-boxes and click “Edit”
to make configurations, or click “Add” to add a new AP group:
The AP Settings panel can enable or disable Auto Approve for
all Managed APs. When enabled, Managed APs will
automatically join the AP Array with the Controller AP. When disabled,
Managed APs must be manually approved to join the AP Array with the
Controller AP.
Enable or disable Auto Approve for all Managed APs.
To manually approve a Managed AP, use the allow “Action” icon for the
specified AP:
Edit AP:
Configure your selected AP on your LAN. You can set the AP as a DHCP client
or specify a static IP address for your AP, and assign the AP to an AP group, as
well as edit 2.4GHz & 5GHz wireless radio settings. Event log is displayed at
the bottom of the page.
You can also use Profile Settings to assign the AP to WLAN, Guest Network,
RADIUS and Access Control groups independently from AP Group settings.
Click “Save” to save the settings. Click “Cancel” to forfeit the changes. Click
“Save and Apply” to save and apply the settings.
To Next Page
Loading...
Need help?
General
