101
V Appendix
V-1 Configuring your IP address
The access point uses the default IP address 192.168.2.2. In order to access
the browser based configuration interface, you need to modify the IP address
of your computer to be in the same IP address subnet e.g. 192.168.2.x (x = 3 –
254).
The procedure for modifying your IP address varies across different operating
systems; please follow the guide appropriate for your operating system.
In the following examples we use the IP address 192.168.2.10 though you can
use any IP address in the range 192.168.2.x (x = 3 – 254).
If you’ve changed the AP Controller’s IP address, or if your
gateway/router uses a DHCP server, make sure you enter the correct IP
address. Refer to your gateway/router’s settings. Your computer’s IP
address must be in the same subnet as the AP Controller.
If using a DHCP server on the network, it is advised to use your DHCP
server’s settings to assign the AP Controller a static IP address.
To Next Page
Loading...
Need help?
General
