Why are the bearings or gears overheating in my Edwards 900-607-MH05 Water Pump?
If your Edwards Water Pump bearings or gears are overheating, ensure the oil level is correct. If the oil level is correct, consider that the oil may be contaminated, and change it. Check for coupling misalignment and realign the coupling. Also, readjust the alignment and tension if there is excessive belt tension.
What causes oil loss in my Edwards 900-607-MH05 Water Pump?
If you're experiencing oil loss in your Edwards Water Pump, replace the plug 'O' rings, as the oil filler or drain plug may be leaking. Also, check seal 'O' rings and vacuum joints for vacuum leaks. If these aren't the cause, the seal may be worn, in which case you should replace the seal, static ring, and 'O' rings.
General| Model | 900-607-MH05 |
|---|---|
| Category | Water Pump |
| Power Source | Electric |
| Material | Cast Iron |
| Type | Centrifugal |
| Voltage | 230V |
To Next Page