© Edwards Limited 2012. All rights reserved. Page 29
Edwards and the Edwards logo are trademarks of Edwards Limited.
Service, spares and accessories
M518-00-880 Issue A
7 Service, spares and accessories
7.1 Introduction
Note: You must not drain the oil from the pumping system. You must clearly state the pump is full of oil when
you complete form HS2.
Edwards products, spares and accessories are available from Edwards companies and distributors worldwide. These
centres employ Service Engineers who have undergone comprehensive Edwards training courses. Order spare parts
and accessories from your nearest Edwards company or distributor. When you order, please state for each part
required:
1. Model and Item Number of your equipment.
2. Serial Number (if any).
3. Item Number and description of the part.
7.2 Service
Edwards products are supported by a worldwide network of Edwards Service Centres and distributors. Each Service
Centre offers a wide range of options including: equipment decontamination; service exchange; repair; rebuild and
testing to factory specifications. Equipment that has been serviced, repaired or rebuilt is returned with a full
warranty. Your local Service Centre can also provide Edwards engineers to support on-site maintenance, service or
repair of your equipment. For more information about service options, contact your nearest Service Centre or other
Edwards company.
Edwards can provide training, tooling and spares to enable users to overhaul their pumping systems.
7.3 Ordering accessories
A variety of accessories are available for CXS - contact Edwards for advice and details.
7.4 Spares
For spares, please refer to the individual CXS or EH booster manuals, or contact Edwards for advice and details.
Whenever you return the system to an Edwards Service Centre or other Edwards company, you
must comply with the requirements of Section 6 and with the requirements of the Return of
Edwards Equipment Procedure (refer to forms HS1 and HS2 at the rear of this manual).
To Next Page
Loading...
