Edwards Drystar EDP80 Series User Manual

© Edwards Limited 2011. All rights reserved. Page 13
Edwards and the Edwards logo are trademarks of Edwards Limited.
Technical data
A705-40-880 Issue B
2.11 Connections
Table 11 - Connections
Pump-inlet connection
EDP80 50 Hz 60 Hz 2 inch ANSI 150 lbf raised face flange
EDP160, EDP250, EDP400 50 Hz 60 Hz 3 inch ANSI 150 lbf raised face flange
Pump-outlet connection
EDP80, EDP160 50 Hz 60 Hz 1.5 inch ANSI 150 lbf raised face flange
EDP250, EDP400 50 Hz 60 Hz 2 inch ANSI 150 lbf raised face flange
Recommended pump-inlet and pump-outlet seals PTFE envelope gaskets: ‘KLINGER’ milled type
with a 1.5 mm full-face insert
Shaft-seals purge nitrogen inlet 1/4 inch compression fitting
Cooling-water supply
Inlet 50 Hz 1/2 inch BSP female
Outlet 50 Hz 1/2 inch BSP female
Inlet 60 Hz 1/2 inch NPT female
Outlet 60 Hz 1/2 inch NPT female
Middle-stage and gas-ballast purge port fittings
type
EDP80 1/4 inch BSP
EDP160, EDP250, EDP400 1/2 inch BSP

Edwards Drystar EDP80 Series Specifications

General

Brand	Edwards
Model	Drystar EDP80 Series
Category	Water Pump
Language	English