© Edwards Limited 2011. All rights reserved. Page iii
Edwards and the Edwards logo are trademarks of Edwards Limited.
Contents
A705-40-880 Issue B
5.15.7 Fit the coupling cover to the new pump-motor ....................................................................58
5.15.8 Refit the pump-motor and coupling cover to the pump (without the motor change frame) ...............58
5.15.9 Refit the pump-motor and coupling cover to the pump (with the motor change frame) ...................59
5.16 Fit a replacement service module ...................................................................................63
5.16.1 Introduction .............................................................................................................63
5.16.2 Prepare the pump ......................................................................................................64
5.16.3 Remove the old service module ......................................................................................64
5.16.4 Inspect the components removed from the service module .....................................................65
5.16.5 Fit the new service module ...........................................................................................65
5.17 Fault finding .............................................................................................................68
6 Storage and disposal ........................................................................... 71
6.1 Storage ...................................................................................................................71
6.2 Disposal ...................................................................................................................71
7 Service and spares .............................................................................. 73
7.1 Introduction .............................................................................................................73
7.2 Service ....................................................................................................................73
7.3 Spares and maintenance kits ..........................................................................................73
7.4 Accessories ...............................................................................................................73
7.5 Ordering options ........................................................................................................73
Index .............................................................................................. 75
For return of equipment, complete the HS Forms at the end of this manual.
Illustrations
Figure Page
1 The EDP pump: sheet 1 of 2 ............................................................................................ 5
2 EDP pump dimensions: mm (sheet 1 of 2) ..........................................................................14
3 Fill the pump with coolant ............................................................................................19
4 Services panel ...........................................................................................................24
5 Flange loading limits ...................................................................................................26
6 Oil-level sight-glass and oil filling and draining connections ....................................................38
7 Exploded view of the pressure relief valve .........................................................................41
8 Exploded view of an oil-level sight-glass ............................................................................44
9 Relubricate the rotor bearings ........................................................................................47
10 Flush the pump ..........................................................................................................50
11 Clean the cooling-water filter ........................................................................................52
12 Clean the cooling-water flow indicator .............................................................................53
13 Clean the heat exchanger .............................................................................................57
14 Exploded view of the pump-motor, torque limiter and coupling cover (pumps with a torque limiter) ...60
15 Exploded view of the pump-motor, coupling drive and coupling cover (pumps without a torque limiter)61
16 Use the motor change frame to lower the pump-motor and coupling cover assembly ......................62
17 Remove/refit the service module ....................................................................................67
To Next Page
Loading...
Need help?
General
