© Edwards Limited 2009. All rights reserved. Page 35
Edwards and the Edwards logo are trademarks of Edwards Limited.
INSTALLATION
A533-23-880 Issue C
Figure 15 - Lifting bolt positions
3.4 Remove the enclosure panels
1. Refer to Figure 16.
2. Remove the HMB left-hand side panel from the iF system:
Place your hand against the top of the left-hand side panel (6) to support it and use a flat-head screwdriver
to release the 3 quarter-turn catches (5).
Swing the top of the panel out slightly and lift out the panel so that the slots in the bottom of the panel
disengage from the pins (7) on the frame.
Fully remove the panel and place it in a safe location.
3. To remove the HMB right-hand side panel: use the method in Step 2 above.
4. Remove the FDP right-hand and left-hand side panels: use the method in Step 2 above.
1. Four lifting-bolts (use all four when lifting the iF1800)
To Next Page
Loading...
