Edwards iXL600

© Edwards Limited 2015. All rights reserved. Page 53
Edwards and the Edwards logo are trademarks of Edwards Limited.
Appendix A1
A540-55-880 Issue D
A1.4.7 FIT ACCESSORY menu
Under the Setup menu. Scroll by pressing up/down keys. Press ENTER to open a sub menu or CANCEL to exit back to
the Setup menu.
For an accessory press the up/down keys to select Fitted or Not Fitted and press ENTER to accept or CANCEL to exit
back to the COMMANDS menu.
Note: Gate Valves additionally have an option of Fitted No Feedback for use where there are no position feedback
switches fitted to the gate valve.
A1.4.8 IP Configuration menu
Under the Setup menu. Scroll by pressing up/down keys. Press ENTER to open a sub menu or CANCEL to exit back to
the Setup menu.
Display only items press CANCEL to exit back to the IP Configuration menu.
Table A8 - FIT ACCESSORY menu
Gate Valve…
Water Sensor… (Analogue water flow)
Active Gauge…
Exh Gas Temp… (Exhaust Gas Temperature)
Table A9 - IP Configuration menu
Host_Name… (display only)
DHCP Enable… (Enabled / Disabled)
*
*
Press the up/down keys to select Enabled or Disabled and press ENTER to accept or
CANCEL to exit back to the IP Configuration menu.
IP Address… (xxx.xxx.xxx.xxx)
†
†
For each address setting press the up/down keys to set the digit, press ENTER to
accept and move to the next digit or CANCEL to move back to the previous digit.
Pressing ENTER at the end of the line will accept the new setting and exit back to the
Edit IP menu. Pressing CANCEL at the start of the line will cancel and exit back to the
IP Configuration menu.
Address Mask… (xxx.xxx.xxx.xxx)
†
DNS Server… (xxx.xxx.xxx.xxx)
†
Gateway… (xxx.xxx.xxx.xxx)
†
NTP Server… (display only)
SMTP Server… (display only)
MAC Address… (display only)
Domain Name… (display only)