A540-55-880 Issue D
Page 54 © Edwards Limited 2015. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Appendix A1
A1.4.9 Display attributes menu
Under the Setup menu. Scroll by pressing up/down keys. Press ENTER to open a sub menu or CANCEL to exit back to
the Setup menu.
SELECT LINE (Normal display selection menu)
Scroll by pressing up/down keys. Press ENTER to open a sub menu or CANCEL to exit back to the Display
Attributes menu.
In each option the SELECT PARAMETER menu is opened, scroll through the parameters by pressing up/
down keys. Press ENTER to select the parameter for display or CANCEL to exit back to the SELECT LINE
menu.
UNITS (Units to display)
Scroll by pressing up/down keys. Press ENTER to open a sub menu or CANCEL to exit back to the Display
Attributes menu.
In each option scroll through the units available by pressing up/down keys. Press ENTER to select the displayed units
or CANCEL to exit back to the UNITS menu.
Note: The configuration options for the PDT are stored in the PDT itself and are not associated with the pump
that the PDT is connected to. This means a user can transfer a PDT between pumps and keep the same
settings. It also means that different units could be displayed on two PDTs connected to the same pump.
Table A10 - Display attributes menu
Normal display (Selects the parameters displayed in Normal)
Units…
Table A11 - SELECT LINE (Normal display selection menu)
To p Pa g e 1 …
Bottom Page 1…
To p Pa g e 2 …
Bottom Page 2…
Table A12 - UNITS (Units to display)
Pressure... (PSI/kPa)
Temperature... (Centigrade/Farenheit)
Speed... (RPM/Hz)
Active Gauge... (mBar/Torr/kPA)
To Next Page
Loading...
