Edwards iXM Series User Manual

3.5 Nitrogen purge data
Table 5 Nitrogen purge data
Characteriscs
Units Rang
Nitrogen supply pressure range bar gauge 2.5 - 6.9
psi gauge 36 - 100
Nitrogen supply quality *
Nitrogen inlet connecon 1/4 inch tube ng
* It is the customer's responsibility to make sure the pump purge gas is correct for the
process gases and by-products being pumped. Where nitrogen is used as a purge gas, it
should be normal industrial grade liquid nitrogen, or an equivalent standard, with an
oxygen and water content no more than 4 ppm.
Table 6 Gas module types and ows
Varimode 96 (Standard)
Mode
Pump
condion
Flow condion
Seable stages ow
range
Fixed ow
Total
ow
4/5 5/6 6/7 Exh SS
O O Nominal individual ow 0 0 0
0 0 0
Total ow 0
Green Running Nominal individual ow 0 0 0
0 4 4*
Total ow 0
On-Min Running Nominal individual ow 1 3 4
4 4 16
Total ow 8
On-Nominal Running Nominal individual ow 2 15 19
4 4 44
Total ow 36
On-Max Running Nominal individual ow 5 37 46
4 4 96
Total ow 88
* Nitrogen ow reducon during Green Mode requires special conguraon. Contact the supplier for
advice on applicaon and acvaon.
3.6 Electrical data
Table 7 Pump electrical data
Characteriscs
Units 3000
1200
1200T
1200TX
600
600T
200
200T
Rated system input power at maximum load kW 4.7 4.8 4.8 3.0
Dry pump motor rang kW 1.9 1.9 1.9 1.9
Mechanic
al booster motor rang kW 4.5 1.9 1.9 -
10/2020 - ©Edwards Limited
Page 18M56635880_D
M56635880_D - Technical data

Edwards iXM Series Specifications

General

Brand	Edwards
Model	iXM Series
Category	Water Pump
Language	English