Edwards TIC

© Edwards Limited 2010. All rights reserved. Page 5
Edwards and the Edwards logo are trademarks of Edwards Limited.
Technical data
D397-50-880 Issue C
Table 5 - Pin connections for 9-way sub-miniature ‘D’ type socket
2.4.2 D.C. Power connector
Table 6 - D.C. power connector
Figure 2 - Pin connections for the 2-way Power Connector
2.4.3 RS232 Connector (TIC Version only)
Table 7 - RS232 connector (TIC version only)
Pin Allocation
1 Chassis (box)
2 Not connected
3Profibus Data + (B)
4 Control Signal for Repeater
5 Profibus Data reference (Isolated)
6 Profibus 5 V output (Isolated)
7 Not connected
8 Profibus Data - (A)
9 Not connected
Shell Chassis (box)
Connector type 2 Way Receptacle. Mating part is cable-mount Terminal
Block (supplied).
Suitable parts include: Phoenix MSTBV 2.5/2-G-5.08;
Weidmuller BLZ 5.08/2; Amp 796634-2; IMO 21.950/2
(Refer to Figure 2).
Requirements See Section 2.1
Connector type 9-way sub-miniature ’D’ type Plug (refer to Figure 3)
For connection to serial comms port of Turbo Instrument
Controller only.
RS232 protocol 9600 baud, 1 stop bit, 8 data bits, no parity