D397-50-880 Issue C
Page 28 © Edwards Limited 2010. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Operation
4.8.7 Software module 902 - TIC Software Version
General Description
Module used in TIC Profibus unit to read the software version it contains. This would normally only be
used during setup or test; as it can't alter during data exchange it would not normally be present.
Output bytes (from Master)
None.
Input bytes (to Master)
Associated Parameter options
None.
4.8.8 Software module 904 - Turbo Pump control
This module should be used with any Turbo pump that is compatible with a TIC unit.
General Description
Controls Turbo pumps connected to a TIC.
Output bytes (from Master)
Input bytes (to Master)
1st Release state of software in ASCII, should be 'P' for production.
e.g.ASCII ’P’ = 50 h.
2nd Version letter of software in ASCII, normally A to Z. e.g.ASCII’A’
= 41 h.
1st Stop if value 0. Run if value 1. Leave alone if value 99 (dec). See
note in Section 4.8.17.
1st State - refer to table in Appendix A1.
2nd Alert - refer to table in Appendix A2.
3rd Priority - refer to table in Appendix A3.
To Next Page
Loading...
