Edwards TIC

© Edwards Limited 2010. All rights reserved. Page 17
Edwards and the Edwards logo are trademarks of Edwards Limited.
Operation
D397-50-880 Issue C
Note: If the address is set to a value greater than 125 (decimal) the RED error LED will flash at around 1 Hz and
the module will not go on-line. If this occurs either, change the address and cycle the power or remove
power and change the address.
Address in
Decimal
Upper switch
setting
Lower switch
setting
Address in
Decimal
Upper switch
setting
Lower switch
setting
30 1 E 93 5 D
31 1 F 94 5 E
32 2 0 95 5 F
33 2 1 96 6 0
34 2 2 97 6 1
35 2 3 98 6 2
36 2 4 99 6 3
37 2 5 100 6 4
38 2 6 101 6 5
39 2 7 102 6 6
40 2 8 103 6 7
41 2 9 104 6 8
42 2 A 105 6 9
43 2 B 106 6 A
44 2 C 107 6 B
45 2 D 108 6 C
46 2 E 109 6 D
47 2 F 110 6 E
48 3 0 111 6 F
49 3 1 112 7 0
50 3 2 113 7 1
51 3 3 114 7 2
52 3 4 115 7 3
53 3 5 116 7 4
54 3 6 117 7 5
55 3 7 118 7 6
56 3 8 119 7 7
57 3 9 120 7 8
58 3 A 121 7 9
59 3 B 122 7 A
60 3 C 123 7 B
61 3 D 124 7 C
62 3 E 125 7 D