UPS: MKD 700 – 3000 VA RT (XL) Operation and Service
been eradicated and the error status reset. Then the UPS switches
again to the bypass made and can be started again.
Deleting the event log: The UPS event log can be deleted here.
Resetting the UPS to the original factory settings: If the UPS does
not work properly after you have entered your settings, the original
settings can be recalled here. This tasks, like many other settings, can
only be performed when the device is in the STANDBY mode.
Fig. 6-4 Model navigation in the “CONTROL” submenu.
To Next Page
Loading...
