CONTENTS Page
1 Range of Applications 6
1.1 Use in Accordance with Regulations 6
2 Scope of Supply 6
2.1 Special Accessories 7
3 Putting into Service 7
4 Setting and Putting into Service with the Aid of the Fast Installation Routine (SIR) 7
5 Quick access 10
5.1 Parameter back up 10
5.1.1 Parameter backup 10
5.1.2 Restoring parameters from the backup 10
5.1.3 Save the parameter backup on a USB stick 11
5.1.4 Restoring the parameter backup from the USB stick 12
5.2 Setting the reference position 13
6 Setting the Basic Functions 14
6.1 Direction of motor rotation 14
6.2 Use of a HSM001 Hall Sensor Module or IPG... Pulse Encoder 14
6.3 Transmission Ratio 15
6.4 Selection of Functional Sequences (Thread Trimming Operations) 15
6.5 Key functions of the input in1 15
6.6 Positioning speed 15
6.7 Maximum Speed Compatible with the Sewing Machine 16
6.8 Maximum speed 16
6.9 Positions 16
6.9.1 Setting the reference position (Parameter 170) 17
6.9.2 Setting the positions 17
6.10 Control display of signal position and stop position 18
6.11 Positioning shift 18
6.12 Braking Characteristics 18
6.13 Braking Power at Standstill 18
6.14 Starting Characteristics 19
6.15 Operating hours counter 19
6.15.1 Set and Reset Operating Hours Counter 20
6.15.2 Total Operating Hours Display 20
7 Functions 20
7.1 Softstart 20
7.1.1 Softstart speed 20
7.1.2 Softstart stitches 20
7.2 Sewing foot lifting 21
7.3 Reverse motor rotation 21
7.4 Unlocking the Chain (Mode 5/6/7) 22
7.5 Machine run blockage 23
7.6 Thread trimming operation 23
7.6.1 Thread Trimmer/Thread Wiper (Lockstitch Modes) 23
7.6.2 Trimming speed 23
7.6.3 Chainstitch thread cutter (var. modes) 24
To Next Page
Loading...
