Efka AB600A5010 - Parameter List; Operator Level Parameters

- AB600A5010 Parameter List
- 50 -
12 Parameterlist
12.1 Operator Level
The preset values indicated apply to mode 0 (Parameter 290 = 0).
For preset values applicable to other modes see table in chapter 11.1 »Preset Values Depending on Mode«.
Parameters
Designation
Unit
Max
Min
Preset
Ind.
002 c3
Number of stitches of cutter at seam begin
Stitches
254
0
2
003 c4
Number of stitches of cutter at seam end
Stitches
254
0
2
004 LS
Light barrier compensating stitches
Stitches
254
0
7
005 LSF
Number of stitches of the light barrier filter for knitted
fabrics
Stitches
254
0
1
006 LSn
Number of light barrier seams
15
1
1
007 Stc
Number of stitches for the seam with stitch counting
Stitches
999
0
20
009 LS
Light barrier On/Off
1
0
0
013 FA
Thread trimmer On/Off
1
0
0
014 Fw
Thread wiper On/Off
1
0
0
015 StS
Stitch counting On/Off
1
0
0
017 SAb
Stop for tape cutting at the seam end On/Off
(Function only when overlock mode is active).
1
0
0
018 UoS
0 = Sequence “overlock mode with stop”
1 = Sequence “overlock mode without automatic stop. When the
command “run” is given, the drive runs at the pre-selected
speed. With pedal in pos. 0 or light barrier covered, the
program switches to the next start of a seam without issuing
signals M1/M2.
2 = As with setting “1”. But with pedal in pos. 0 signals M1/M2 will
be issued, and the program switches to the next start of a
seam.
3 = As with setting “1”. But with pedal -2 signals M1/M2 will be
issued, and the program switches to the next start of a seam.
Intermediate stop and sewing foot lifting with pedal in pedal -1
is possible.
4 = If the light barrier is covered during the end count for chain
suction, the program switches immediately to the next start of a
seam. If the end count has been completed and the light barrier
remains uncovered, the drive stops.
5 = Tape cutting at the start of the seam with stop
5
0
0