Heat
Sets the air conditioner into heating mode with a set temperature of 75°F
(24°C).
• With the unit on or off, press the button and the unit will enter
heating mode with a set temperature to 75°F (24°C).
• In the timer on state, press this button to cancel the timer setting
and turn on heating mode with a set temperature to 75°F (24°C).
• In sleep state, press this button run the heating mode with a set
temperature to 75°F (24°C).
Tem p
In cooling, heating, and dehumidifying modes, press the “up arrow” or
“down arrow” to adjust the temperature setting ranging from 60°F − 90°F
(16°C − 32°C).
Note: The temperature is not adjustable in the air supply mode.
Fan
Select the blower output speed of:
"Breeze / Low / Mid / Med-High / High / Auto".
Note: There is no automatic wind speed in air supply mode.
Timer
Press the "timer" button to turn on the timer, then press the "up/down"
button to set the time. The range is 1-24 hr. time-period. Press the "timer"
button to complete the selection. If the timing has been set, press the
"timer" button again to cancel the timing.
Turbo
Enables the fan to run at a maximum speed. When in turbo mode, the fan
speed display on the remote control will disappear. The indoor unit will be
noticeably louder when running in Turbo mode.
Note:
• Pressing the fan speed will cancel the "Turbo" function.
• Enabling Sleep mode will cancel the Turbo function.
• Turbo mode cannot be enabled in automatic mode,
dehumidification mode, air supply mode, or when the timer or
AC Power Limiter
Press the “AC Power Limiter” button to limit the amount of AC input when
solar input is also being used. Note: Not available with this unit. This
feature only works on hybrid models.
Turns the indoor unit LED Display off or on.
Sleep
Press the "sleep" button to turn on sleep mode. The fan speed and
temperature automatically adjust, but the remote-control display remains
unchanged. The unit will automatically exit sleep mode after 8 hours of
continuous operation in sleep mode and revert to the previous running
state.
Note: Sleep mode cannot be turned on in air supply mode.
Adjusts the air output direction up or down.
Left and Right Wind
Direction
This feature is not available on this unit. The left and right wind direction
can be changed using the levers inside the louver opening.
This feature is not available on this unit.
This feature is not available on this unit.
To Next Page
Loading...