EasyManua.ls Logo

EG4 9K AC MINI-SPLIT - 2 Safety; Safety Instructions; Important Safety Notifications

EG4 9K AC MINI-SPLIT
46 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
2. SAFETY
DANGER! Hazardous Voltage Circuits!
AVERTISSEMENT! Circuits à tension élevée!
2.1 SAFETY INSTRUCTIONS
International safety regulations have been strictly observed in the design and
testing of the mini-split. Before beginning any work, carefully read all safety
instructions, and always observe them when working on or with the mini-split. The
installation must follow all applicable national or local standards and regulations.
Incorrect installation may cause:
Injury or death to the installer, operator or third party
Damage to the mini-split or other attached equipment
2.2 IMPORTANT SAFETY NOTIFICATIONS
There are various safety concerns that must be carefully observed before, during,
and after the installation, as well as during future operation and maintenance. The
following are important safety notifications for the installer and any end users of this
product under normal operating conditions.
1. This equipment requires the handling and installation of high-pressure
gasses and hazardous levels AC and DC voltages. Ensure that all wiring is
compliant with local regulations.
2. All electrical work must be performed by a licensed technician in accordance
with local regulations and the instructions provided in this guide.
3. Only authorized service technicians should repair or perform maintenance
on this unit.
4. If the unit operates abnormally (emits strange noises or a burning smell),
immediately turn off the unit and disconnect the power to avoid electric
shock, fire, and/or injury. Call the distributor for further assistance.
5. When moving or relocating the air conditioner, consult experienced service
technicians for disconnection and re-installation of the unit.
6. Personal Protection Equipment (PPE) must be used while installing this
equipment. The manufacturer and any resellers of this equipment assume
no responsibility for any failure to properly protect personnel from injury.
7. Failure to follow all applicable safety standards will result in a void of
warranty.
8. The unit contains fluorinated gases. For specifics on the type of gas used,
please refer to the label on the outdoor unit.
9. Never supply power to the unit unless all wiring and tubing are completely
connected and re-checked.
10. If the air conditioner is used together with burners or other heating devices,
thoroughly ventilate the room to avoid an oxygen deficiency.
11. This unit must be properly grounded and plugged into a GFCI-rated outlet.