3. BRIEF INTRODUCTION
3.1 MINI-SPLIT FEATURES
EG4 mini-split air conditioners consist of an indoor unit and an outdoor unit. Each mini-split
has the capability to cool and heat, based on the need. The unit comes pre-charged with
refrigerant supporting a DIY installation. Each unit comes with a remote control and can also
be controlled by a smartphone via a third-party application.
3.2 PACKING LIST
1 1 Indoor Unit
2 1 Indoor Unit Mounting Plate (ships attached to indoor unit)
3 1 Remote Control
4 2 AAA Battery
5 1 Signal Cable (indoor unit to outdoor unit)
6 1 Outdoor Unit
7 1 Weather Protection Wrapping Tape
8 1 Drainpipe 5 ft. length x .59 in. diameter (1.5m x 15mm)
9 1 Wall Sleeve
10 1 Sealant Putty
11 1 Manual
13 1 16.4 ft. (5m) Line Set (refrigerant lines) with Quick Connect fittings
14 3 Screws
15 3 Sleeve Anchor
4. INSTALLATION TOOLS
The following bulleted list shows the different tools that may be required to properly install both the
indoor and outdoor units.
• Drill with drill bit set
• 2.5 in. hole saw
• Phillips head screwdriver
• Adjustable wrenches
• Level
• Painter’s tape
• Marker or pencil
To Next Page
Loading...