EggRider V2 - 3.2 EggRider Display Specification

3.2 EggRider display specification
SIZE
75mm x 47mm x 35mm
WEIGHT
31g
CABLE LENGTH
50cm
HANDLEBAR MOUNTING BRACKET
Standard 22.2mm diameter
CLAMP SCREW
Hex bolt M3x10mm
MOUNTING CLAMP PIN
2.0mm diameter and around 15mm length
PHYSICAL BUTTONS
Power On/O, Level Up/Down and popular Road/ORoad mode switch
CONNECTOR
Higo/Julet waterproof 5 pin male/female (see image)
CONNECTIVITY
Bluetooth low energy (BLE)
PROTECTION
Dust and water-resistant - IP65 protection
VOLTAGE
Supports direct voltage up to 60V (we can support higher voltages only with specic controllers by
connecting to 12V output)
Current consumption
Full brightness: <= 20 mA
Low brightness (dimmed) <= 12 mA
•
•
3.2 EggRider display specication
- 14/89 -
Copyright © 2019 EggRider.