EggRider V2 - 6.2 Bafang

6.2 Bafang
6.2.1 Bafang settings
Bafang switch mode setup
This settings are relative only to the Bafang controllers integrated in their mid-drive units (such as the BBSxx series). Most of the
times the Bafang hub motors don't have these settings available, since they use dierent controllers (such as Lishui, Kunteng,
etc.)
Attention
If you are not familliar with the Bafang settings we recommend using Only live data for Bafang switch mode in Display settings
page until you understand their functionality. For more information on how to proceed visit the Mobile App/Display settings page
section.
Attention
If you experience intermittent power cuts, it is most probably because you reach a speed limit or voltage cuto. It can also be due to
wrong conguration on the Pedal advanced settings.
Info
By using a low gear, your motor may not reach its full potential.
Info
Available with rmware and mobile app version > v2.2.07
6.2 Bafang
- 42/89 -
Copyright © 2019 EggRider.