EggRider V2 - Frequently Asked Questions

13. Frequently asked questions
Am I required to have the phone connected to the display while riding?
No, EggRider display works withouth the need of the mobile app connection.
Can I connect with more than one phone?
Yes, you can use more phones to connect to EggRider display, you have to activate for every phone.
Why are my EggRider settings not saved?
When you write the EggRider settings from the app to the display, they are saved permanently only when
you press the
Power
on the display.
What is the maximum power EggRider supports?
EggRider can support virtually any power. You have to keep in mind that the maximum power it is given by
your motor controller and that it can't be bypassed.
Why do I get an alert even if I updated my EggRider: "Your EggRider display version (Unknown/v2.x.x) is lower than the
supported version by the app (v2.x.x)?"
You have to connect with the app to the display to make the warning dissapear after an update.
What does "R10", "R35"... means on the display?
The Rxx represents the range in km/mi. If there is an error it will be replaced with Exx representing the
error code.
Why trip data is not registered when my phone is in the pocket?
You have to make sure the app is allowed to run in the background. Please search for "Lock App in
background"
When does a trip stop recording?
At every connection a new trip is started and it ends on disconnection or by pressing "Restart" icon on the
Dashboard page.
13. Frequently asked questions
- 88/89 -
Copyright © 2019 EggRider.