EggRider V2 - 6.6 Kunteng Settings (KT)

6.6 Kunteng settings (KT)
Consists of one common settings section shared by both proles Road and ORoad and prole independent
settings.
Speed limits are used from EggRider display settings page.
Read
- reads the settings stored on the display
Write
- writes the modied settings to the display.
6.6.1 Kunteng Common Settings
Motor speed demultiplier
Wheel speed pulse signal (P2)
Options are 0, 1, 2, 3, 4, 5, and 6.
Assist mode (P3)
Options
Speed control / PAS Gear Ratio
Torgue I Max Power
PAS no of magnets(C1)
Options are 0, 1, 2, 3, 4, 5, 6 and 7.
Phase codification
Options are 0, 1, 2, 3, 4, 5, 6 and 7.
Unfortunately due to some hardware incompatibility in communication voltage levels we decided to discontinue the Kunteng(KT)
version until further notice. If you are a customer that already purchased this version and you are experiencing issues please get
back to us.
Discontinued
Accessible from menu Kunteng
After writing settings, turn o your display from the
Power
button in order to permanently save the settings.
Attention
•
•
6.6 Kunteng settings (KT)
- 67/89 -
Copyright © 2019 EggRider.