EggRider V2 - 6.3 Lishui Settings (LSW)

6.3 Lishui settings (LSW)
Consists of common settings section shared by both proles Road and ORoad and prole independent
settings.
Read
- reads the settings stored on the display
Write
- writes the modied settings to the display.
Lishui controllers do not broadcast factory setting values, so in particular cases you have to nd the right
settings for your controller by trying dierent combinations.
6.3.1 Settings explanation
PAS Type
Side on which the PAS sensor is mounted. However there are many cases where the bike manufacturer
modies the sensor slightly, so please use the other way around if the assist doesn’t work correctly.
Options
Left
Right
Speed Sensor magnets number
Represents the number of magnets used for speed measurement. Most hub motors have an additional hall
switch on the shaft for speed measuring purposes. In this case please set it to 1. Some other might have the
speed sensor on the motor before the reduction, if that is the case please set it to 5.
Voltage cutoff base
The base under-voltage protection at controller.
Options are
21V - for 24V batteries
31.5V - for 36v batteries
42V - for 48v batteries
Accessible from menu Lishui
After writing settings, turn o your display from the
Power
button in order to save the settings permanently.
Some settings take eect only after a power on/o cycle.
Attention
•
•
•
•
•
6.3 Lishui settings (LSW)
- 56/89 -
Copyright © 2019 EggRider.