Wheel Size
Internal controller wheel size in inches. This is used for internal controller speed limit purposes and it does
not aect the speed measurements of the display.
Options are 16", 18", 20", 22", 24", 26", 700C, 28"
Assist Pulse Delay
This settings determines how fast the motor assist starts when using the pedals. Lower values will make the
motor assist quicker.
PAS Gain
Can be a value between 0 and 255 and is correlated to the PAS number of magnets. Example of values:
128 - for PAS with 6 magnets
64 - for PAS with 12 magnets
This eld can have dierent behavior but mainly is the pedal assist power
Throttle limited by PAS level
Options
Yes - Throttle power is limited by the assist level
No - Throttle has maximum power all the time regardless of the assist level
Throttle limited to 6 Km/h
Options
Yes - Throttle works only up to 6 kph.
No - Throttle is available at any speed
PAS startup acceleration
The power ramp for assist. Lower value means softer start.
Options are 0, 1, 2, 3.
Voltage cutoff deviation (0.1 V)
Value to ne tune the battery voltage cuto. If your battery shuts down before reaching 0% this should be
increased.
You have to sum this value to the base cuto voltage to get the actual voltage cuto the motor will impose.
To avoid accidental power on we recommend using a value that starts the motor assist after at least half turn of the pedals
Attention
•
•
•
•
•
•
6.3.1 Settings explanation
- 57/89 -
Copyright © 2019 EggRider.
To Next Page
Loading...