For example if voltage cuto base is 31.5V and voltage cuto deviation is -2.5V then your actual voltage cuto
will be 29V.
This eld accepts values between -12.6 and 12.7v with increments of 0.1 volts.
Current Limit (0.5 A)
Value to set main power of the bike. Lower value means lower power.
This eld accepts values between 0A to 31.5A with increments of 0.5 ampere.
Speed limit
Internal controller speed limit at which assistance is stopped.
Running strategy
These are dierent algorithms strategies to try to overcome some of the Lishui protocol limitations.
SPEED LIMITATION
When in speed limitation, the values that are used from power levels are only the speed %.
This can have a dierent result based on the controller conguration. Some Lishui controller are limited in
speed, so this option will change the speed limit of each assist level. Other Lishui controllers are limited in
current so this option will change the current limitation of each assist level.
CURRENT LIMITATION
When in current limitation, both values power and speed % are used.
Power % is used to change the current limit and speed is used to limit the assistance based on the display
settings speed limits.
RADPOWER MODE
Replicates the RadPower original display running mode. When using this option you should set to 5 assist
levels.
Please do not exceed the maximum current you can nd on your controller label. Also keep in mind that some controllers are not
accepting values lower than a threshold resulting in defaulting to a specic value.
Attention
In this mode throttle will be limited by pass level even if the option is set to No in the settings.
Please keep in mind that if Power % * Current limit is lower than the controller accepted threshold then it will default to a dened
value which will be higher which will result in an undesired assist level behavior.
Attention
6.3.1 Settings explanation
- 58/89 -
Copyright © 2019 EggRider.
To Next Page
Loading...