EggRider V2 - 5.6 Display Advanced Settings

5.6 Display advanced settings
5.6.1 Voltage calibration
This should be done only if the voltage displayed is not accurate or the battery percentage is not 100% after
you just fully charged your battery.
The calibration is maintained once the operation is successful, so it is not necessary to repeat.
Full battery method
With full battery select your battery voltage and then press Calibrate
Multimeter method
If you have a multimeter at hand, insert the battery voltage read with your multimeter under FullVoltage
and then press Calibrate
Voltage calibration for more than 2.5V example
EggRider voltage read is 38V and you know that the voltage should be 41.6V.
(41.6V - 38V = 3.6V > 2.5V)
Steps
Write into FullVoltage 40V (38V + 2V), press "
Calibrate
"
Check that the new voltage shown on the dashboard is 40V and get back to display advanced settings
Repeat step 1, 2 until the voltage dierence is lower than 2.5V
Write into FullVoltage 41.6 (40 V + 1.6 V), press "
Calibrate
"
Check that the new voltage shown on the dashboard is is 41.6V.
Available with rmware and mobile apps version > v2.1.0
Full battery (preferably just after disconnected from the plug) or a multimeter.
Essential
Please ensure that you have the right Voltage 0% and 100% relative to your battery which can be found in EggRider settings page.
You can select from the drop down Select to auto-ll these values.
Attention
If your voltage dierence is greater than 2.5V you will receive a popup alert. If you are sure about your voltage then follow the steps
used for the following example (adapt accordingly):
Attention
1.
2.
3.
4.
5.
5.6 Display advanced settings
- 35/89 -
Copyright © 2019 EggRider.