EggRider V2 - Page 43

FIRST CONFIGURATION
Make sure display is set to Road mode
Select Live data and settings for Bafang switch mode in the Display settings page, press Write then
Read to check its saved.
After rst connection, an automatic read for Bafang Basic, Pedal and Throttle pages will be executed. At the
end of this procedure both proles Road and ORoad would be identical. In case of failure this action can
be triggered manually from
Initialize
from one of the pages
Make sure to save the initial conguration from every page before modifying. (Take screenshots of all the
pages).
Modify settings as desired
You have to
Write
successfully to be able to use switch mode from display or mobile app
Switch prole settings by pressing
Road
or
OffRoad
from any page.
SUCCESSIVE CONFIGURATIONS
Make sure display and mobile app are showing the same Road or ORoad mode.
Follow steps 5, 6, 7 from First Conguration
BAFANG ERROR CODES
E03 - Brake ON (03H)
E04 - Throttle doesn’t go back (in the furthest position) (04H)
E05 - Throttle fault (05H)
E06 - Low voltage protection (06H)
E07 - Over voltage protection (07H)
E08 - Hall signal wires fault on the motor (08H)
E09 - Phase wire fault on the motor (09H)
E10 - Controller temperature is too high, and reaches the protection point (10H)
E11 - Temperature sensor inside controller fault (11H)
E12 - Current sensor fault (12H)
E13 - Temperature sensor inside battery fault (13H)
E14 - Temperature sensor inside the motor fault (14H)
E21 - Speed sensor fault (21H)
E22 - BMS communication fault (22H)
E23 - Light fault (23H)
E24 - Light sensor fault (24H)
E25 - Torque sensor torque signal fault (25H)
Do not change prole by pressing
M
on display during this procedure.
Important
1.
2.
3.
4.
5.
6.
7.
1.
2.
If the app and display are out of sync, use
Read controller
to see the last settings written to controller by either the app/display or
your own tool.
Attention
6.2.1 Bafang settings
- 43/89 -
Copyright © 2019 EggRider.