EasyManua.ls Logo

EggRider V2 - Page 48

EggRider V2
89 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6.2.2 Bafang basic settings
Buttons
Initialize
- Reads all Bafang Basic/Pedal/Throttle settings at once. After this procedure both Road/ORoad
would have identical settings.
Road
or
OffRoad
- switch between proles.
Read controller
- reads Bafang Basic settings.
Info
- provides information for the Bafang switch mode.
Write
- writes the Basic settings to controller. If the operation is successful it updates the settings on the
display as well.
BATTERY SETTINGS
LOW BATTERY PROTECT (V)
Value to prevent battery voltage cuto(most likely your battery will have a BMS that will shut o power when
the voltage gets too low). If your battery shuts down before reaching this value you should increase it.
LIMITED CURRENT (A)
Represents the global current limit in ampers (A).
Accessible from menu Bafang Basic.
Please use settings in the range for your motor for Low Battery Protect and Limited Current. Each controller has its own harware
limitations which cannot be bypassed. The controller will reject values outside its capabilities.
Attention
To have no power on Level 0, set both Current and Speed Limit to 0. In some cases it is required a value of 1.
Info
For 48V battery packs it sould be set aproximately to 43V
This sets the power level that the drive unit will pull from the battery pack. Be aware that just because it is set lower, it does not
mean that it may not draw more amps for brief periods. If you don’t want to stress the battery pack, you may want to set this number
a bit lower than you think (2-3 amps lower). This preventive measure is benecial for lower powered units such as BBS02, if your
watt meter shows that it is pulling too much power on a regular basis. This variable will be set lower than 25 if you have a BBS01 or
a BBS02 with a lower power level rating than 750W. If this is set lower than 25 from the factory you CANNOT RAISE it safely unless
you are sure it is a 750 Watt unit & controller (it should be specied on the bottom of the unit) and your battery can handle the draw
.
6.2.2 Bafang basic settings
- 48/89 -
Copyright © 2019 EggRider.