EggRider V2 - Page 50

6.2.3 Bafang pedal settings
Buttons
Initialize
- Reads all Bafang Basic/Pedal/Throttle settings at once. After this procedure both Road/ORoad
would have identical settings.
Road
or
OffRoad
- switch between proles.
Read controller
- reads controller Pedal settings.
Info
- provides information for the Bafang switch mode.
Write
- writes the Pedal settings to controller. If the operation is successful it updates the settings on the
display as well.
BASIC
DESIGNATED ASSIST
The value of the assist power level.
If set to Display command the assist level shown on the display would be considered.
SPEED LIMIT
The value of the speed limit.
If set to Display command the value from Max Speed Road or Max Speed ORoad from Display settings
page will be used.
START CURRENT(%)
The initial percentage of current delivered. This variable is vital for not killing the controller. The lower the
Start Current is set the less power is directed to the PAS system upon startup, this will create less strain on
the controller and on your bike's drivetrain when starting from a standstill, especially if you are in a gear that
is too high. 100% Start Current will peak at well over 1000w draw. A lower value will give you a smoother
acceleration.
Accessible from menu Bafang Pedal
To disable pedal assist set Dessignated Assist = 0 and in Bafang Basic page set for Assist 0, Limited Current(%) = 0 and
Limited Speed(%) = 0.
Tip
To have always maximum power for pedal assist set Dessignated Assist = 9 and in Bafang Basic page set for Assist 9, Limited
Current(%) = 100 and Limited Speed(%) = 100.
Tip
6.2.3 Bafang pedal settings
- 50/89 -
Copyright © 2019 EggRider.