EINHELL TC-TS 210 User Manual

GB
- 28 -
•
Warning!
Always hold the guided part of the workpiece.
Never hold the part which is to be cut off .
•
Push the cross stop (14) forward until the
workpiece is cut all the way through.
•
Switch off the saw again.
Do not remove the off cut until the blade has
stopped rotating.
9. Replacing the power cable
Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
10. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
10.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
10.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualifi ed electrician.
Danger! The carbon brushes should not be rep
laced by anyone but a qualifi ed electrician.
10.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
10.4 Ordering spare parts and accessories
Please provide the following information when
ordering spare parts:
•
Type of unit
•
Article number of the unit
•
ID number of the unit
•
Spare part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
Tip! For good results we
recommend high-quality ac-
cessories from !
www.kwb.eu
welcome@kwb.eu
10.5 Transport
Only ever transport the machine by lifting it by the
saw table. Never use the safety devices such as
the saw blade guard and stop rails for handling or
transporting purposes.
11. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
12. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature.
The ideal storage temperature is between 5 and
30 °C. Store the electric tool in its original pa-
ckaging.
Anl_TC_TS_210_SPK9.indb 28Anl_TC_TS_210_SPK9.indb 28 07.11.2019 08:49:3107.11.2019 08:49:31

EINHELL TC-TS 210 Specifications

General

Idle speed	4800 RPM
Cutting height @ 45°	27 mm
Cutting height @ 90°	45 mm
Input power	1200 W
AC input voltage	220-240 V
AC input frequency	50 Hz
Number of teeth	24
Saw blade included	Yes
Protection class	II
Package weight	13500 g

Weight and Dimensions

Depth	562 mm
Width	477 mm
Height	390 mm
Weight	11300 g
Table depth	440 mm
Table width	525 mm
Blade diameter	210 mm
Blade thickness	2.6 mm
Height adjustment range	0 - 45 mm