Eizo ColorEdge CS2410 User Manual

21
Chapter 3 Advanced Adjustments/Settings
Function Settings Description
Input Color Format Auto
*2
YUV 4:2:2
YUV 4:4:4
RGB
The color space of the input signal can be specied.
Try changing this setting if colors are not displayed correctly.
Normally, select "Auto".
Note
• Cannot be set for DVI input.
Input Range Auto
*3
Full
Limited (109%
white)
Limited
Depending on the external device, the black and white levels
in the video signal output to the monitor may be restricted. If
the signal is displayed on the monitor in its restricted form, the
blacks will be faint, the whites dull, and contrast will be reduced.
The brightness range of such signals can be extended to match
the actual contrast ratio of the monitor.
• "Auto"
The monitor automatically recognizes the brightness range of
input signals and displays images appropriately.
• "Full"
The input signal brightness range is not extended.
• "Limited (109% white)"
The brightness range of the input signal is
extended from
16 - 254 (10 bits: 64 - 1019) to 0 - 255 (10 bits: 0 - 1023) for
display.
• "Limited"
The brightness range of the input signal is
extended from
16 - 235 (10 bits: 64 - 940) to 0 - 255 (10 bits: 0 - 1023) for
display.
Noise Reduction On
Off
The small noises that occur in dark areas of an image are
reduced. Use this function to reduce noise and roughness in
images.
Note
• This can only be set when there is HDMI input.
• Using the Noise Reduction function may lead to deterioration
of ne images.
*2 Only enabled when input signal information for automatically determining the setting is detected
*3 Disabled during DVI input

Eizo ColorEdge CS2410 Specifications

General

Brand	Eizo
Model	ColorEdge CS2410
Category	Monitor
Language	English