Eizo ColorEdge CS2410 - Chapter 5 Troubleshooting; No Picture

27
Chapter 5
Troubleshooting
Chapter 5 Troubleshooting
5-1. No Picture
Problem Possible cause and remedy
1. No picture
• Power indicator does not light up.
• Check whether the power cord is connected properly.
• Turn on the main power switch on the rear side of the monitor.
• Touch
.
• Turn off the main power switch on the rear side of the monitor,
and then turn it on again a few minutes later.
• Power indicator is lighting white. • Increase "Brightness" and/or "Gain" in the Setting menu (see
“Color” (page 16)).
• Power indicator is lighting orange. • Switch the input signal.
• Move the mouse or press any key on the keyboard.
• Check whether the external device is turned on.
• Turn off the main power switch on the rear side of the monitor,
and then turn it on again.
• Power indicator is ashing orange and
white.
• This problem may occur when an external device is
connected via the DisplayPort connector. Connect via the
signal cable specied by EIZO, turn off the monitor, and then
turn it on again.
2. The message below appears. This message appears when the signal is not input correctly even
though the monitor is functioning properly.
• This message appears when no signal is
input.
Example:
• The message shown left may appear, because some external
devices do not output the signal immediately after power-on.
• Check whether the external device is turned on.
• Check whether the signal cable is connected properly.
• Switch the input signal.
• Turn off the main power switch on the rear side of the monitor,
and then turn it on again.
• Try changing "Signal Format" in the "Administrator Settings"
menu (see “Signal Format” (page 26)).
• The message shows that the input signal
is out of the frequency specication range.
Example:
• Check whether the external device is congured to meet the
resolution and vertical scan frequency requirements of the
monitor (see “1-3. Supported Resolutions” (page 9)).
• Reboot the external device.
• Change to the appropriate setting using the graphics board's
utility. Refer to the User's Manual of the graphics board for
details.