Eizo DuraVision FDF4627W-IP

12
2.
Connect the power cord to the power connector of the monitor and plug in the
cord to the wall socket.
To power outlet
Attention
• Do not bundle cables when wiring.
• The main power switch is turned on when factory default settings are congured.
Prepare the remote control
Insert batteries into the remote control. The remote control is used for operating and conguring this
monitor.
1.
On the back of the remote control, press the knob to unlock, and remove the
cover.
2.
Input AA batteries, and slide the cover back.
Attention
• Use the remote control within the range illustrated in the diagram below.
5m
5m
20°
20°
7m
5m
30°
30°
7m
5m
• When installing multiple monitors, leave sufcient space between each monitor so that only the intended
monitor will be operated by the remote control. Otherwise, all monitors that receive the remote control signal
will operate accordingly.