25
Chapter4PowerSavingFunctions
4-3. Enabling/Disabling Automatic Brightness
Adjustment “Auto EcoView”
The sensor on the front side of the monitor detects the environmental brightness to adjust the screen brightness
automatically and comfortably by using the Auto EcoView function.
Attention
• Be careful not to block the sensor on the lower side of the monitor when using the Auto EcoView function.
Procedure
1. Press
.
The “EcoView” menu appears.
2. Select “On” or “Off” with or .
3. Press
to exit the adjustment.
Note
• For this reason, as <Brightness> in the Adjustment menu is changed, the auto adjustment range is also changed.
4-4. Setting Indicator “EcoView Index”
This indicator shows the power saving ratio, power reduction and CO2 reduction as a result of the brightness of
the monitor. The power saving ratio comes to high as the indicator level meter lights towards right.
Procedure
1. Press
.
The “EcoView” menu appears.
Note
• Power reduction: the backlight’s reduction of electricity consumption as a result of the adjusted brightness value.
• CO2 reduction: converted from the “Power reduction” value, this is an estimate of the quantity of CO2 emissions
reduced when using the monitor for 1 hour.
* Thenumericvalueisaresultofacalculationbasedonadefaultvalue(0.000555t-CO2/kWh)determined
byaministerialordinance(2006,MinistryofEconomy,TradeandIndustry,MinistryofEnvironment,civil
codearticle3)andmaydifferdependingoncountryandyear.
4-5. Enabling/Disabling Auto Power-OFF <Off Timer>
This function allows you to specify whether to turn on/off the monitor automatically after a specied time has
elapsed in the power saving mode.
Adjustable range
Disable, Enable (0, 1, 2, 3, 5, 10, 15, 20, 25, 30, 45 min, 1-5 h)
Procedure
1. Choose <Others> from the Adjustment menu, and press
.
2. Choose <Off Timer> from the <Others> menu, and press
.
The <Off Timer> menu appears.
3. Select “Enable” or “Disable” with or .
If “Enable” is selected, set a monitor Off time with or .
4. Press to exit the adjustment.
To Next Page
Loading...
