ELCA MAGO - CANCELLATION (ERASING)

ENG man MAGO-EVO 03 MAGO-EVO Radio Remote Control
- Page 17 -
ENGLISH
This procedure deletes all memorized coupling data within the transmitter which prepares the transmitter for a new
coupling procedure.
Attention: with this procedure the receiver which is coupled with the transmitter is no longer controllable (unless a new
coupling procedure is done) and all the settings made by the user in the transmitter will be reset to factory settings.
Verify that the transmitter is OFF and the mushroom STOP released.
7.4 CANCELLATION (ERASING)
A
I
E N
D L
C L
B I
F N
G
START
STOP
Once completed the coupling data within the Transmitter will have been cancelled.
Now it is possible to use this Transmitter to effect a new COUPLING procedure wparagr.7.2.
START
G
Simultaneously press together the  rst step
of the G button with the START button until
the Red LED stops  ashing and the Green
LED  ashes 1  ash per second.
A I
Press A button repeatedly until you see the
 xed White LED 3 light up.
Green LED  ashes.
Press B button to access the ERASING
Menu. You should see White LED 1  ashing.
Green LED  ashes.
START
G
START
Insert the PIN CODE
The default PIN CODE is START, G, START,
unless the operator has registered a personal
code.
Fixed White LED 1 will light up.
Green LED  ashes.
B I
START
G
B I
Press simultaneously the G,START and B
buttons until you see the Green LED  xed
which con rms the Cancellation has been
done.