SAFETY
5/56
EN
1 SAFETY
1.1 Overview
These instructions for the installation, commissioning and maintenance of the burner are for use
by technicians from professional heating companies that are qualied to carry out these activities.
The instructions contain indications and information on how to move, handle, activate, adjust,
maintain and remove the appliance and how to dispose of the components at the end of the their
useful life.
The instructions must be followed and all applicable legislation complied with in order to ensure
safe working conditions.
This manual should be stored near the product and made available to all operators involved in
its use.
1.2 Intended use
The burner is designed to act as a heat source for heating and DHW generation systems in which
water is the heating uid.
Any other or wider application is outside of the specied intended use.
To avoid risks, the burner should only be used:
– for its specically intended use
– under the appropriate safety conditions
– following the instructions for installation, commissioning and maintenance
– in compliance with the max. and min. operating values
– in compliance with the required maintenance activities
– immediately repairing any malfunctions that could compromise safety
– maintaining all notes and notices applied to the product so that they remain legible over time
the burner cannot be installed outdoors, unless installed in a boiler specically designed for that
use. If installed outdoors, climatic conditions could cause direct damage to the burner due to the
presence of water or frost or cause the components to overheat.
To Next Page
Loading...
Need help?
General