33
10 MAINTENANCE
Your gauge is designed to give many years reliable service under normal operating and storage conditions.
The transducer will wear with repeated use. Transducer life depends on the number of measurements taken
and the manner in which readings are taken. To extend transducer life, always set the transducer down so
that it is perpendicular to the panel surface. Dragging the transducer along the surface will reduce the life
of the transducer.
Replacement transducers are available from your local Elcometer supplier or directly from Elcometer.
The gauge does not contain any user-serviceable components. In the unlikely event of a fault, the gauge
should be returned to your local Elcometer supplier or directly to Elcometer.
Contact details can be found:
• On the outside cover of these operating instructions.
• At www.elcometer.com
11 RELATED EQUIPMENT
Elcometer produces a wide range of material thickness gauges and associated inspection equipment.
Users of the Elcometer 207 and 207DL may also benefit from the following Elcometer products:
• Elcometer range of ultrasonic gauges
• Elcometer surface profile gauges
• Elcometer surface cleanliness test kits
Further information can be obtained from your local Elcometer supplier, direct from Elcometer, or by visiting
www.elcometer.com.
To Next Page
Loading...
Need help?
General
