Electia CTC 1132 - Door Chime

CTC-1132 868AM 2007.07.18
12
z Use “S”,”T” keys to switch between
options.
z Press “OK” to confirm.
z 30 sec. is set as factory default.
<
<
N
N
O
O
T
T
E
E
>
>
) Full Arm Exit time applies only to the
zone that a Door Contact or PIR
Detector is installed and is set to
“Entry”.
) If incorrect PIN code is entered and/or
the Exit delay time has expired, then
the system will trigger the Burglar
alarm
7. H. Entry Time
This is for you to select the Entry Delay time
when Home Arming. Options available are 0
sec., 10 sec., 20 sec., up to 70 sec. in 10-sec
increments.
H . E n t r y T i m e
2 0 s e c . (
Λ
V O K )
z Use “S”,“T” keys to switch between
options.
z Press “OK” to confirm.
z 20 sec. is set as factory default.
<
<
N
N
O
O
T
T
E
E
>
>
) Home Arm Entry Delay time applies
only to the zone that a Door Contact
or PIR Detector is installed and is set
to “Entry”.
) If incorrect PIN code is entered and/or
the entry delay time has expired, then
the system will trigger the Burglar
alarm
8. H. Exit Time
This is for you to select the Exit Delay time
when Home Arming. Options available are 0
sec., 10 sec., 20 sec. up to 70 sec. in 10-sec
increments.
H . E x i t T i m e
3 0 s e c . (
Λ
V O K )
z Use “S”,”T” keys to switch between
options.
z Press “OK” to confirm.
z 30 sec. is set as factory default.
<
<
N
N
O
O
T
T
E
E
>
>
) Home Arm Exit Delay time applies only
to the zone that a Door Contact or PIR
Detector is installed and is set to
“Entry”.
) If incorrect PIN code is entered and/or
the Exit delay time is expired, then the
system will trigger the Burglar alarm.
9. Door Chime
This is for you to decide whether the Control
Panel will sound a Door Chime if the Door
Contact or PIR Detector is activated at the
Entry Point while the system is in Disarmed
mode.
Door C h i me On
Door C h i me Of f
z Press “S”,”T” keys to select the option
followed by “¿” appearing next to the
selected option.
z Press “OK” to confirm
z “Door Chime Off” is set as factory default.
<
<
N
N
O
O
T
T
E
E
>
>
) When Door Chime is disabled, there
will be no door chime when Entry
point DC or PIR is triggered at
Disarmed mode.
) When Door Chime is enabled, the
system will make a “Ding-Dong”
sound to inform user that a DC or PIR
at Entry Point is triggered at Disarmed
mode.
10. Time
This is for you to program the current time to
be displayed. (hour & minute)
T i me S e t t i n g
00: 00 (
S
T
OK)
z Hour flashes first, use “S”,”T” keys to
choose a correct number for the current
hour. Hours are indicated by “00 ~ 23”.
z Press “OK” to confirm. Next, the screen