CTC-1132 868AM 2007.07.18
23
press “OK”.
z Entry Snd On, Entry Snd Off
The Outdoor Siren BX-8 can be enabled
or disabled from sounding the Entry Delay
warning beeps.
z Disable the Siren Entry Sound by
selecting “Entry Snd Off” and press
“OK”.
z Enable the Siren Entry Sound by
selecting “Entry Snd On” and press
“OK”.
z Receiver 1, Receiver 2
2 additional Universal Receivers can be
added to the system.
Step 1. Put Universal Receivers into learn
mode (Refer to their individual
Operational Manual).
Step 2. Move the cursor to the position
“Receiver 1”
Step 3. Press “OK”.
Step 4. The Control Panel will then sound a
long beep and transmit Learning code
to UR#1 simultaneously. The UR
status LED lights up for 3 seconds.
<
<
N
N
O
O
T
T
E
E
>
>
) If Receiver 2 is also to be added to the
system, proceed to the following steps:
Step 5. Move the cursor to the position
“Receiver 2”.
Step 6. Press “OK”.
Step 7. The Control Panel will then sound a
long beep and transmit Learning code
to UR#2 simultaneously. The UR
status LED lights up for 3 seconds.
Step 8. Remember to put these Universal
Receivers out of Learn mode. Adding
them into the system is completed.
5. Edit Power Switch “Home Matic”
The controlpanel and powerswitch
communicate with each other by
following steps:
Step 1. Put the Power Switch “Home Matic” in
learning mode.
Step2. Put the Control Panel into
programming menu.
Step 3. Select Device +/- and then “Power
Switch” then the following screen will
be displayed.
Step 4. Select the disired channel number and
press OK.
Step 5. The control panel will sound one beep
and send a signal to the Power
Switch.
Step 6. Repeat Step 4 to learn other channels.
<
<
N
N
O
O
T
T
E
E
>
>
) When the first (Channel 1) Power
Switch “HomeMatic” has been set,
and alarm is triggered, the LED of the
first Power Switch will flash (2-sec On
& 2-sec Off) automatically until the
Control Panel is disarmed.
) If the AC Fault exists in the Control
Panel and the alarm is trigger, the
LED of first (Channel 1) Power Switch
will flash slowly (2-sec On & 6-sec Off)
) Only the first (Channel 1) Power
Switch can flash during the panel
alarm.
VI. SMS Editor
For sending a SMS alarm reporting to your
mobile phone, edit your SMS message by
selecting “SMS Editor“ in Programming Main
menu.
E d i t S c r e e n
1. Editing SMS message
Step 1. During this display, compose your own
SMS message of up to 14x4=56
characters maximum. Press “OK” to
confirm.
The keypad can be used to enter text, similar
Channe l 1
Channe l 2
Channe l 3
Channe l 4
Channe l 5
Channe l 6
Channe l 7
Channe l 8
To Next Page
Loading...