Electia CTC 1132 - 2-Level Passwords; Getting Started

CTC-1132 868AM 2007.07.18
3
V. 2 – level passwords
In order to provide highest security in operating
the system, CTC-1132 offers 2 levels of
authorization. That is
9 Personal PIN Code
9 Master Code
A. PIN Code
z There are a total of 4 User PIN Codes
per each system. The PIN Code is
the 1st level of password. It has the
authorization for daily operation, such
as
9 Arm the system
9 Disarm the system
9 Enter the Home mode
9 Partially arm the system (By-pass
mode)
9 Display Fault events
9 View the Event log
9 Power Switch (Home Matic)
z “1234” is set as default User #1 PIN
Code by the factory.
z User PIN code #2~#4 are deactivated
by factory default
B. Master Code
z The Master Code has the
authorization to enter Programming
mode. In Programming mode, the
following options can be programmed.
9 Add the device in
9 Edit the devices
9 Remove a device
9 Program the External Siren
9 Edit Power Switch “HomeMatic”
9 Set Pin Code
9 Set Temporary Code
9 Set Duress Code
9 Set Master Code
9 Set Telephone Numbers
9 Set Messages
9 Set SMS related Features
9 Select Walk Test mode
9 GSM signal
9 SMS Keyword
z “1111” is set as default Master Code
by the factory.
<
<
N
N
O
O
T
T
E
E
>
>
) No any two codes can be the same, if
so, the message, “Code in use,
Select another” will be displayed to
prompt the user to choose differently .
VI. Getting Started
Step 1. Find a suitable location for the Control
Panel to be installed.
Step 2. Apply the AC Power. You will hear a
long beep. “Alarm On” will be
displayed on the first line and “00:01
01 Jan” displayed on the second line
of the screen indicating the system is
in Away mode (this is the default
mode)
Step 3. Press “ 1 “ key on the keypad, the
display will show.
E n t e r C o d e
¿
. . .
Step 4. Key in the remaining “234” (default
User1PIN code, 1234) within 30 sec.
Step 5. Press “OK”. You will hear 2 short
beeps and the display will show.
A l a r m O f f
0 0 : 0 1 0 1 J a n
The system is now in Disarmed mode.
<
<
N
N
O
O
T
T
E
E
>
>
) In Step 4, press “ “ (cancel) key will
clear one previously entered code.
) “OK” key confirming the entered PIN
code should be pressed within 30 sec.
Otherwise, the display will go back to
“Alarm On” and the system remains
armed.
) During entering PIN code, if more than
20 keys (including “OK” & “
“ key)
were pressed without a valid PIN code