Electia CTC 1132 - Partial (By-Pass) Arm Mode

CTC-1132 868AM 2007.07.18
29
section II, “Away Mode”
4. Forced Arming
z
If there is any fault condition has occurred
or a door was found opened before or any
sensor is triggered, when you press “OK”
in step 3 above or when you press
“Home” button on the Remote Controller,
the Control Panel will sound a ding-dong
warning sound to indicate entering the
Home mode is prohibited. You rectify the
problem first, then clear the fault display,
and then try again. Or you can do forced
arming to enter Home mode compulsorily.
Please follow the instructions described in
“Forced Arming” in Section III.
VI. Partial (By-pass) Arm Mode
The Partial (By-pass) Arm mode allows the
user to de-activate (by-pass) any sensors at
their discretion. This feature allows your home
to be armed; yet the person inside the house
can move freely in the area where the sensor
is by-passed.
To put the system into the Partial (By-
pass) Arm mode:
Step 1. Enter your PIN code and press “OK”
within 10 seconds. The display will
show:
A w a y A r m
H o me A r m
B y p a s s
Step 2. Press “T “ to move the cursor down to
select “Bypass”.
Step 3. Press “OK”
Step 4. All the zones are listed in zone number
order.
D C B a c k d o o r
I R H a l l w a y
D C F r o n t d o o r
I R L i v i n g r o o
m
RC MR . S MI T H
Stop
Step 5. Press “T”, “S” keys to select the zone
to be by-passed.
B y - p a s s : ( O k ? )
D C B a c k d o o r
Step 6. Press “OK” to confirm the selection.
The selected zone will be marked with
a “¿” character in front of it to indicate
that device is to be by-passed.
<
<
N
N
O
O
T
T
E
E
>
>
) The zones can be toggled between by-
passed and not by-passed by
pressing the “OK” key repeatedly
followed by the “¿” character
appearing for By-pass setting and “¿”
character disappearing for By-pass
unsetting.
Step 7. You can repeat Step 5 ~ Step 6 to
continue selecting the device to be by-
passed.
Step 8. After all the sensors to be by-passed
have been selected, press “ “ to
return to user menu and the cursor
stays at “Arm”.
Step 9. Press “OK” to select “Arm” and to arm
the system.
<
<
N
N
O
O
T
T
E
E
>
>
) If a sensor is by-passed, then the
Contorl Panel will not respond to its
triggering in Arm mode.
) The by-pass setting is effective for only
one time, once the system is disarmed,
the by-pass setting is cleared
automatically.
) When a sensor is by-passed, the
system can be armed directly
regardless of its fault situation (if any).
However, its fault situation is still being
monitored and will be logged and
displayed when you access the “Log”
submenu.