Electia CTC 1132 - Appendix; Reset Procedure; Reset to Factory Default; A P P E N D I

CTC-1132 868AM 2007.07.18
40
Appendix
I. Reset Procedure
 Reset to Factory Default
Setting
The Control Panel can clear all programmed
parameters by the following sequence:
1. Power down Control Panel and remove the
battery
2. Apply power while holding down the “S”
key.
3. Release the “S” key when a tone is heard,
“Enter Code” will be displayed.
4. Enter the following keys sequence:
“STSTSTST”, “OK”
5. Press the “ ” key
6. All programmed parameters are reset to
factory default setting.
7. If more than 17 incorrect keys entered,
then the unit will revert to normal “Alarm
On” mode.
<
<
N
N
O
O
T
T
E
E
>
>
) Once the “System Reset” is executed,
all the programmed data are returned
to its default value and all the devices
having been learnt-in are removed.
You have to do the programming and
learn in the device one by one again.