Electia CTC 1132 - Configuring Your System; Entering Programming Mode

CTC-1132 868AM 2007.07.18
4
strings, it will inhibit further key
presses for 1 minute.
) In Step3, if you press a key other than
numeric keys, the display will remain
the same requesting you to key in
“1234” (default PIN code) and then
press “OK”.
) The Control Panel has “Screen Save”
function. The “Alarm off” message
will be displayed for 160 sec. only.
Afterwards only current date & time is
displayed on the second row line.
Step 6. Please wait for 2 to 3 minutes for the
system to read it status. Then, if the
yellow LED turns on, it indicates that
there is a fault. Press “1234” to enter
the user menu within 30 sec.
Step 7. Press “OK” and the display will show.
F a u l t D s p
A w a y A r m
H o m e A r m
B y p a s s
L o g
P o w e r S w i t c h
Step 8. Choose “Fault Dsp” and press “OK”
The following possible Fault will
display:
Configuring your system
I. Entering Programming mode
If the system is in Disarmed (Alarm off) mode,
to enter the Programming mode, follow the
steps below.
Step 1. Press “#” key.
The screen will prompt you to enter
the User1 PIN code.
P - M o d e E n t e r
P - C o d e . . . .
Step 2. Key in “1234” (default “User1” PIN
code) within 30 sec. Then, press “OK”
The screen will prompt you to enter
the Master PIN code.
P - M o d e E n t e r
M - C o d e . . . .
<
<
N
N
O
O
T
T
E
E
>
>
) During keying in the PIN code, press
“
“ will clear one previously entered
code. If the code field is empty, press
“
“, the screen will exit and return to
“Alarm Off” screen.
Step 3. Key in “1111” (default “Master” Code)
within 30 sec.
Step 4. Press “OK”
The following message is displayed
for 2 sec.
P r o g r a m M e n u
M a k e a S e l e c t i o n
Step 5. Then the Programming Main menu will
be displayed.
O
W
a l k T e s t
Tel.S e t t i n g v
<
<
N
N
O
O
T
T
E
E
>
>
) The cursor is indicated by a flashing dot
on the left upper corner. It can be
move up & down by pressing “S” &
“T” key respectively.
Step 6. Press “S” “T” keys to move the cursor
downward or upward. The screen is
also scrolled down or up respectively.
The following items can be selected.
9 Walk Test
9 Tel. Setting
9 Gen. Settings.
9 Spc. Settings
9 Devices +/-
9 SMS Editor
9 SMS Keyword
9 Country Code
9 GSM Signal
9 Reset GSM
Step 7. After making a selection by moving the
cursor to the desired item, press “OK”
to confirm the selection. The display
will show you the individual
programming screen accordingly.
<
<
N
N
O
O
T
T
E
E
>
>
) If a down-arrow symbol “V” appears on