CTC-1132 868AM 2007.07.18
16
system enters “Home Arm” or “Disarm”
mode, the timer automatically starts again.
12. Tamper Alarm
This extra option is to choose for Tamper Alarm
of unauthorized sabotage to the devices only
when the system is “Away Armed” in addition
to the normal operational directive of Tamper
Alarm.
A w a y A r m O n l y
N o r ma l V
z Use “T” & “S” keys to select the options.
z Press “OK” to confirm.
z “Away Arm Only” is set as factory default.
13. Supervision
This extra option is used to enable system
supervision function. When this option is
chosen “ON”, CTC-1132 will be able to receive
the check-in signals from its system devices to
indicate their proper functioning.
D i s a b l e
4 H o u rs
6 H o u rs
8 H o u rs
1 2 H o u r s
z Use “T” & “S” keys to select the options.
z Press “OK” to confirm.
z “Disable” is set as factory default.
14. Set SIM-Code
Before proceeding with this step, the SIM Card
must be inserted and the Control Panel must
have already been powered on for longer than
3 minutes. After above mentioned condition is
met, this step is for you to set the PIN code of
the GSM SIM card.
Move the cursor to the “Set G.P-Code”, and
then press “OK”. The display will prompt you
to enter the PIN code of your SIM card:
E n t e r N e w ( + 0 K )
P - C o d e . . . .
z Enter your new GSM PIN Code and
confirm by pressing “OK”.
z The screen will then display a message
prompt saying, “Wait for a minute. Please”
z Afterward, another message prompt will
confirm, “Pin-Code has been changed”
and the display automatically return to the
“Special Setting Menu”.
<
<
N
N
O
O
T
T
E
E
>
>
) Press “ “ to escape and the screen
returns to “Special Setting Menu”
z Change GSM Pin Code
GSM Pin Code can be changed at user’s
discretion.
z When Old Pin Code is requested, enter
Old Pin Code followed by OK.
z Proceed to “Set G.P-Code” as instructed
in this section.
15. Stop
Press “OK” to return to the previous menu.
V. Add / Delete Device
If “Devices +/-“ is selected in Programming
Main menu, the “Device +/-“ menu is displayed.
From here you can edit all the devices
previously learnt-in, add or delete devices
including the external sirens.
A d d D e v i c e
E d i t D e v i c e s
R e m o v e D e v i c e
P r o g r a m S i r e n
Power S w i t ch
1. Adding Devices
Step 1. To learn in a sensor, move the cursor
to the position “Add Device”, then
press “OK”, a prompting message is
displayed.
*
P u s h B u t t o n O n
*
Devi ce t o A dd!
Step 2. Press the test button on the sensor or
any button on the Remote Controller.
Step 3. If a signal is detected, the screen will
show you the type of the device on the
second line.
D e t e c t e d ( O k ? )
D o o r C o n t a c t
To Next Page
Loading...